IJTEEE

Open Access Journal of Scientific, Technology & Engineering Research


International Journal of Technology Enhancements and Emerging Engineering Research (ISSN 2347-4289)
QUICK LINKS
CURRENT PUBLICATIONS



IJTEEE >> Volume 3 - Issue 4, April 2015 Edition



International Journal of Technology Enhancements and Emerging Engineering Research  
International Journal of Technology Enhancements and Emerging Engineering Research

Website: http://www.ijteee.org

ISSN 2347-4289



Experimental Analysis Of Heat Transfer And Friction Factor For Counter Flow Heat Exchanger

[Full Text]

 

AUTHOR(S)

K. Sivakumar, Dr. K. Rajan, S. Murali, S. Prakash, V. Thanigaivel, T.Suryakumar

 

KEYWORDS

Keywords: Counter flow, CFD, Heat transfer

 

ABSTRACT

Abstract: This article reports experimental investigation of heat transfer and friction factor characteristics with different flow rates by means of CFD simulation. In this work is conducted by the double pipe heat exchanger with counter flow direction. The data acquire from the plain tube double pipe heat exchanger with the CFD simulation and ensure the validation results. The plain tube with dissimilar mass flow rates were also studied for comparison assessment. A commercial CFD package, Ansys CFD analysis was used in this study and 3D models of double pipe heat exchanger was generated in this simulation.

 

REFERENCES

[1] sami D.salman, Abdul Amir H.Kadhum,Mohd S.Takriff, and Abu Bakar Mohamad “Numerical investigation of heat transfer and friction factor characteristic in a circular tube fitted with V-Cut twisted tape inserts”Hindawi publishing corporation,volume 2013,Article ID 492762.

[2] V. Hejazi, M.A. Akhavan-Behabadi and A. Afshari, Experimental investigation of twisted tape inserts performance on condensation heat transfer enhancement and pressure drop, International Communications in Heat and Mass Transfer, Vol. 37 (2010), pp. 1376–1387.

[3] L. Syam Sundar and K.V. Sharma, Turbulent heat transfer and friction factor of Al2O3 Nanofluid in circular tube with twisted tape inserts, International Journal of Heat and Mass Transfer, Vol. 53 (2010), pp. 1409–1416.

[4] S. Eiamsa-ard, P. Nivesrangsan, S. Chokphoemphun and P. Promvonge, Influence of combined non-uniform wire coil and twisted tape inserts on thermal performance characteristic, International Communications in Heat transfer, Vol. 37 (2010), pp. 850–856.

[5] Sarma P.K, Subramanyam T., Kishore P.S, Dharma Rao V, Sadik Kakac, 2003. Laminar convective heat transfer with twisted tape inserts in a tube, International Journal of Thermal Sciences, Vol. 42, pp. 821-828.

[6] Jaisankar.S, Radhakrishnan T.K., Sheeba K.N. and Suresh S., 2008. Experimental studies on heat transfer and friction factorcharacteristics of thermosyphon solar water heater system fitted with left-right twisted tapes, International Journal of Applied Engineering Research, Vol. 3, No. 8, pp. 1091-1103