Simulation And Hardware Implementation Of Pro-tection System For High Power Inverters Using FPGA Controller
Ravindra Singh Rajput
Keywords : Introduction of project, high power inverter, FPGA, Simulation Result, hardware etc.
ABSTRACT: This topic illuminates to develop the protection system for high power inverters using FPGA (field programmable gate array) software. The current system consists of thyristor for the high power inverters and according to the simulation results hardware implementation is done with FPGA controller board. For the reference values for FPGA code generation, one power circuit can be developed with ZCD circuit, according to the result of the power circuit FPGA controller will work in such a way that if any fault occurs in the system then the system will be protected. FPGA board can be interface with the hardware and in software of FPGA program can be developed for the feedback of the protection system. However the system which can be developed in hardware or power circuit can be modify also with other power ratings and according to that FPGA controller will work and the system for the protection of the high power inverters can be easily implemented.
 International Journal of Emerging Science and Engineering (IJESE) ISSN: 2319–6378, Volume-1, Issue-5, March 2013. Design of Snubber Circuit for Thyristors Using Pspice by Nancy Merin Thomas.
 T. M. Undeland, F. Jenset, A. Steinbakk, T. Rogne, and M. Hemes, “A snubber configuration for both power transistors and GTO PWM inverters,” in Con$ Rec. 1984 IEEE Power Electron. Specialist Con$(PESC), pp. 42-53.
 I. Khan, J. Tapson and I. De Vries, “Automatic Fre-quency Control of an Induction Furnace”, Proc. IEEE Con$, A@icon ’99, v01.2, September 1999, pp. 913-916.
 J. M. Ho and F. C. Juang, “4 Practical PWM Inverter Control Circuitry for Induction Heating and Studying of the Performance under Load Variations”, Proc. IEEE Con$ International Symposium on Industrial Electronics, vol. 1, July 1998, pp. 294-299.
 F. Blaabjerb, R. Teodorescu, M. Liserre, and A. V. Tim-bus, “Overview of Control and Grid Synchronization for Distributed Power Generation Systems,” IEEE Trans. Ind. Electron., Vol. 53, pp. 1398-1408, Oct.2006.
 J. Satry, O. Ojo, and Z. Wu, “High-performance control of boost ACDC PWM rectifier/induction generator system,” IEEE Trans. Ind. Appl., vol. 42, no. 5, pp1146-1154, Sept./Oct., 2006.
 Nancy Merin Thomas “International Journal of Emerging Science and Engineering (IJESE)” ISSN: 2319–6378, Volume-1, Issue-5, and March 2013.  A Large-Capacity GTO Inverter with Low-Loss Snubber Circuits. N. Kawakami, S. Ueda, Member, IEEE, M. Hombu, Senior Member, IEEE, A. Ueda, Member, IEEE, and Y. Jifuku. IEEE TRANSACTIONS ON IN-DUSTRY APPLICATIONS, VOL. 29, NO. 6, NOVEM-BER/DECEMBER 1993. Short-circuit protection for three phase power inverters, International IOR rectifier, the power management leader.
 Design of snubber circuit of thyristor using Pspice, International Journal of Emerging Science and Engineering (IJESE) ISSN: 2319–6378, Volume-1, Issue-5, March 2013.
 Digital-Controlled Single-Phase Transformer-Based Inverter for Non-Linear Load Applications Ming-Shi Huang, Member, IEEE, Po-YiYeh, Student Member, IEEE, U-Ting Yeh, and Meng-Gu Huang , IEEE TRANSACTIONS ON INDUSTRIAL INFORMATICS, VOL. 9, NO. 2, MAY 2013.